Monoblocks 12000-50000 – innovative RO units

Innovative patented APRO 12000-50000 LPH RO monoblocks: more efficient, less expensive, consume less energy, recovers more water, last longer, easier to service.

• Multiarray of monoblocks
• Purified water recovery up to 98%, high permeate recovery smooth operating (patented high frequency membrane cleaning concentrate discharge)
• Low energy consumption Grundfos booster pump and high flow, low energy recirculation pump (save up to 50%+ of electricity)
• Self-sufficient monoblocks with “slave” controllers and smart master controller (cloud optimization)

Specific design:

• Mass produced multipurpose, off-the-shelf inexpensive monoblocks. No need for special design, expensive customization.
• Multiarray advantage, minimal needed number of monoblocks is working at any given time.
• Water purifier operates always at maximum efficiency.
• Allow You to turn on the required number of systems, depending on the consumption mode, which is much water and power economical than turning on one large systems of the same capacity.
• Redundancy: each monoblocks is independently maintained and, if required, serviced.
• Management console for monoblocks control
• If consumer will need additional monoblock, more blocs can be added later.

Benefits of Monoblocks 12000-50000

Reduced operational cost

Space saving design

High-quality equipment
for longer operation

Silent operation

Features of Monoblocks 12000-50000

Basic Equipment

Modbus
MP controller with TDS/flow/pressure monitoring
Grundfos pumps
Fully equipped electric board
Antiscalant dosing pump with level switch
Viking Pre-filters

Optional Equipment

Supply pumps and storage vessels
Antiscalant
GSM

Technical specification of Monoblocks 12000-50000

MODELAPRO 6000
Membrane Quantity
6
Max inlet water TDS, ppm
2000
Max salt reduction, %*
Up to 90
System recovery, %**
Up to 98
Membrane type
6 x 8040
Power supply
380V, 50 Hz
Dimensions, mm
2800 × 840 × 1150
Net weight, kg
389
Sizing (inlet, outlet, concentrate)
2”/ 1”/ 1”

* Maximum salt rejection according to membrane manufacturer.
** Depends on feed water quality.

Possible systems capacities:

• 2 monoblocks - 12000 LPH

• 3 monoblocks - 18000 LPH

• 4 monoblocks - 24000 LPH

• 5 monoblocks - 30000 LPH

• 6 monoblocks - 36000 LPH

• 7 monoblocks - 42000 LPH

• 8 monoblocks - 48000 LPH

We use cookies to give you the best experience on our website. By continuing you agree to receive all cookies on all AQUAPHOR websites.